Dishwasher BAUKNECHT GSFL 3131 IN - Page: (1)

Preview for user manual

<
>
Sponsored links
Sponsored links
GB
-1-
Chart
PROGRAM SELECTION
BUTTON
Push “Programs” button
(repeatedly) until the indicator
of the required program lights
up (see “Table of programs”
below).
CANCEL/OFF BUTTON
Push this button to switch off the control panel.
If pressed when a program is running it cancels the
program ongoing draining water for 1 minute.
If pressed when the dishwasher is switched off it
drains any possible liquids from dishwasher
(1 minute process).
If the indicator flashes repeatedly, see page 6 -
chapter ”What to do if ...”.
(see at right for options description)
START/RESUME BUTTON
Push this button to start the selected program: the
indicator lights up and goes off at the end of the
program. When the door is opened during a
washing cycle, the cycle is temporarily paused: the
Start indicator blinks. To resume the cycle close
the door and push Start button again.
1) Program data obtained in conformity with European standard EN 50242, obtained under normal conditions
(without additional options) and may vary depending on conditions. Differences of up to 20 minutes are possible
with sensor programs as a result of the appliance’s automatic calibration system.
2) Reference program for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for
detailed information on the EN/Standard loading comparison test and other tests, contact the following address:
“nk_customer@whirlpool.com”.
3) The antibacterial action has been tested by the Institut Pasteur of Lille (France), based on the NF EN 13697
standard of November 2001.
Ta b l e o f p r o g r a m s
Deter-
gent
Consumption
P
Programs
Available
options
Loading instructions
Litres kWh
Minutes
1)
1
Sensor 50-65°C
Delay
Antibacterial
rinse
Recommended program for
routine washes, with dried-
on food (e.g. EN 50242).
X 7-14 1.00-1.60 70-155
2
Pre-Wash cold
Delay
Crockery to be washed
later.
4.0 0.03 14
3
Quickwash 45°C
Delay
Lightly soiled crockery, with
no dried-on food.
X 11.0 0.80 30
4
Bio Normal
2)
50°C
Delay
Antibacterial
rinse
Normally soiled crockery.
Energy-saving program.
X 12.0 1.05 165
5
Intensive 70°C
Delay
Antibacterial
rinse
Recommended program for
heavily soiled crockery,
especially suitable for pans
and saucepans.
X 14.0 1.55 155
5019 496 01689
BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ
THIS QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!
THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING
ANY BUTTON EXCEPT CANCEL/OFF BUTTON.
FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES
AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED.
SALT INDICATOR
When lit (at the end of the
cycle), the salt reservoir
needs to be refilled.
ANTIBACTERIAL RINSE
3)
This function activates an
antibacterial rinse at the end
of the wash cycle,
guaranteeing a further
reduction of bacteria. Press
the button to activate or
deactivate the function. This
function can be used with
the programs indicated in
the table of programs. The
dishwasher door must be
kept shut for the entire
duration of the program in
order to guarantee
reduction of bacteria. If the
door is opened the indicator
lamp starts flashing.
TABLET SETTING
This setting allows to optimize the cycle performances
according the type of detergent used.
Push the Tablet button for 3 seconds (until the indicator
lights up) if you are using the combined detergents in
tablet (rinse aid, salt and deteregent in 1 dose).
If you are using powder detergent or liquid detergent,
the Tablet indicator on the control panel has to be off.
DELAYED START
BUTTON
The wash cycle can be
programmed to start
after 2, 4 or 8 hours.
Then press the Start
button. The wash
program will start after
the set time.
RINSE AID INDICATOR
When lit (at the end of the
cycle), the rinse aid
dispenser needs to be
refilled.
GSFL 3131
Options and display description
Quick reference guide
Sponsored links
< Prev
Next >
All trademarks and brands are the property of their respective owners.